How do you change an inner tube on a mountain bike?

Change a Mountain Bike Tube Without Tools

1. Step 1: Deflate Tire and Loosen Bead. Most likely you’ll be able to skip this step as the tire is already flat.
2. Step 2: Pull Off One Side of the Tire.
3. Step 3: Remove the Tube.
4. Step 4: Put in the New Tube.
5. Step 5: Adjust Valve Stem.
6. Step 6: Push the Tire Wall Back Inside the Rim.

What pressure should my bike tires be at?

Pump it up. Proper tire pressure lets your bike roll quickly, ride smoothly, and avoid flats. Narrow tires need more air pressure than wide ones: Road tires typically require 80 to 130 psi (pounds per square inch); mountain tires, 25 to 35 psi; and hybrid tires, 40 to 70 psi.

How much does it cost to replace a bike inner tube?

Common Bike Repair labor rates ​Inner tubes typically cost $8. Specialty tubes (extra long valves, odd sizes, thorn proof, etc.) may cost more. Bikes with internally geared hubs or full chain cases cost more due to extra time, complexity, or component rarity.

Can you change an inner tube without removing the wheel?

To replace the inner tube, you must remove the wheel from the bicycle. But to patch the inner tube, you need only expose it, without removing the wheel. A wheel with axle nuts is harder to remove and replace than one with a quick release.

What size tube does my bike need?

When you buy an inner tube, the packaging will usually list which diameter and width it fits, according to the purchase manual. For example, if an inner tube says it’s best for 26 x 1.95-2.125″, that means the tube should be used for a 26-inch tire with a width between 1.95 and 2.125 inches.

What tools do you need to change a bike tire?

Wheel Removal

1. Repair stand (optional, makes the work a lot easier)
2. Tire levers such as the TL-1.2, TL-4.2, TL-5, TL-6.2, or a multi-tool that incorporates a tire lever.
3. Patch Kit such as the GP-2 or VP-1.
4. Air pump: either a floor or hand pump.
5. Wrench for non-quick-release type wheels that use outer axle nuts.